Intelligent Cleaning Set (WM Doll)

The WM Doll Intelligent Cleaning Set is a powered washing kit for your doll's internal canals, supplied with its own diatomite drying stick.

It is made for WM's TPE and silicone dolls, for owners who want a powered alternative to rinsing the love holes with the irrigator that comes with every doll.

How it works

The set is built around a control host with a small screen and buttons, which runs from the supplied power adapter. Fill one bucket with clean water (more than 5.5 L) and put the water inlet pipe in it. Put the outlet pipe in an empty bucket that holds 5.5 L or more. The cleaning jet goes into your doll, and the host washes, dries and disinfects, either in one automatic cycle or one step at a time. Once the washing is done, the diatomite drying stick goes in to absorb any moisture left inside.

Cleaning programmes

Automatic. Long-press the power button for 3 seconds, press A, then press Start. The cycle takes about 50 minutes:

• Washing with ultrasonic cleaning: 10 minutes
• Drying with ultrasonic vibration: 20 minutes
• Drying with UV disinfection: 20 minutes

Manual. Press M, then pick one step and press Start:

• Wash (washing with ultrasonic vibration): 30 minutes
• Ultrasonic vibration: 30 minutes
• Dry: 60 minutes
• UV disinfection: 20 minutes

You can pause a programme and carry on, or cancel it, at any point.

Which dolls it suits

We offer it with dolls from WM Doll, in TPE and in silicone.

What is included

• 1 control host
• 1 cleaning jet
• 1 water inlet pipe
• 1 power adapter
• 1 diatomite drying stick

How to use it

1. Lay a towel beneath your doll's buttocks, or place her in the bath, to catch the runoff.
2. Set up the two buckets and connect the power, inlet pipe and outlet pipe.
3. Insert the cleaning jet 2 to 5 segments deep, with the drain pipe facing down and the first raised ring inside. Use lubricant on the jet if your doll is tight. Do not push it in too shallow.
4. Start a programme and keep the hoses clear and unbent while it runs.
5. Wash each canal thoroughly after every use.
6. Insert the drying stick gently to absorb the moisture left inside, and pat the opening dry with a soft cloth.
7. Keep water away from the head and neck: the neck joint is metal and can rust.

Care and safety

• Never wash the control host with water. Make sure the water inlet pipe is connected before you use it.
• The cleaning jet is waterproof and dustproof (IP68), so it can be washed.
• Use clean water, with no debris larger than 1 mm.
• A little water may be left inside your doll after a wash. Use the drying stick, which can be used again.
• A small amount of water left inside the machine from factory testing is normal.
• The quick-connect joints click when they are fitted. To remove one, hold it and pull straight back.